Punching down icky pic coated wires?
The 66 block on the left is completely covered with goo (not just the left side of it). How did the at&t technician manage to do that?
Is that box to the right of the 66 blocks an at&t ONT
Not a very clean job. I do hate that gel solvent, but at least I'd try to clean off the wires better then that. Also the block and bracket appeared to be old/used. Either the tech had something bouncing around the back of his truck, or the general contractor dug up the old stuff that they removed before the demo.
Seems like a rushed job to me. Also noticed that the 66 bracket is upside down. No supports on the cable, held up just by the 66 block and the bends around the electrical panel.
The only reason why I think that it might have been an AT&T tech that did this and not another contractor is because of the tag, and that the termination was wired correctly. I don' think a local sparky could have done this correctly.
The other block and box is the customer's existing Toshiba PBX that was hung back up next to the AT&T block..
