Mitel Sx 50 loop start|Sundance Business VOIP Telephone Help

Print Thread

Rate Thread

Mitel Sx 50 loop start #111151 01/26/10 04:52 AM
Joined: Jan 2010 Posts: 4 Civille, IN Neal OP Member
OP Neal Member Joined: Jan 2010 Posts: 4 Civille, IN	Help with Mitel sx 50,I am trying to convert ground start phone lines from AT&T to regular phone line( like home lines),because they are cheaper Command 501-580 register 2 g= 0, is this the only changes I need to do or is there more commands Thanking you Neal NP

Atcom VoIP Phones

Best VoIP Phones Canada

Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.

Re: Mitel Sx 50 loop start #111152 01/26/10 05:16 AM
Joined: Dec 2005 Posts: 7,056 Fayetteville, NC Lightning horse RIP Moderator-Mitel, Panasonic
Lightning horse RIP Moderator-Mitel, Panasonic Joined: Dec 2005 Posts: 7,056 Fayetteville, NC	That's it. Keep in mind that various problems typically associated with loop start lines on PBX's will probably rear their ugly heads! Make sure: 1 g is set to 0. 2 c & d are set to 0. f is set to 1. 5 c 0 unless customer absolutely MUST have trunk conferencing. If you're lucky, that will take care of problems. If you go to Vonage, M/J or other SIP type trunks, then you've smacked a whole new hornets nest!!! Oh, and ,John C When I was young, I was Liberal. As I aged and wised up, I became Conservative. Now that I'm old, I have settled on Curmudgeon.

Re: Mitel Sx 50 loop start #111153 01/26/10 05:37 AM
Joined: Jan 2010 Posts: 4 Civille, IN Neal OP Member
OP Neal Member Joined: Jan 2010 Posts: 4 Civille, IN	I hope it works, Thank you NP

Re: Mitel Sx 50 loop start #111154 01/26/10 07:59 PM
Joined: Jan 2010 Posts: 4 Civille, IN Neal OP Member
OP Neal Member Joined: Jan 2010 Posts: 4 Civille, IN	The loop start worked, made a call hangup, but the truck would not disconnect, even with forced command *20, than I change the wire polarity and it works. Thank you NP

Re: Mitel Sx 50 loop start #111155 01/28/10 06:26 AM
Joined: Dec 2005 Posts: 7,056 Fayetteville, NC Lightning horse RIP Moderator-Mitel, Panasonic
Lightning horse RIP Moderator-Mitel, Panasonic Joined: Dec 2005 Posts: 7,056 Fayetteville, NC	Neal, yep, that'll happen! are your alarms turned on or off? Register 1 bit c . When I was young, I was Liberal. As I aged and wised up, I became Conservative. Now that I'm old, I have settled on Curmudgeon.

Hop To

Link Copied to Clipboard

atcomsystems.ca/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems Mitel Sx 50 loop start