sundance-communications.com/forum Forums TDM Business Telephone Systems Mitel Telephones & Systems Mitel help req

Recently I took over a hotel site with a Mitel Sx 200 Digital . It has two power supplies and two floppy 3.5 drives on the lower shelf of the cabinet.
I am new to the digital and have never programmed one. I was able to plug in my laptop into the RS232 Port on the cabinet marked maintenance and using hyper terminal emulation I was able to carriage return and enter programming via the installer and pass code.
I had a problem exiting and moving through commands however. Can anyone explain the programming procedure .
What I need to check is an analog extention that is supposed to hotline to the taxi company, but calls the reception when the handset is picked up instead.
Also the Voicemail which is a PC based software with 4 analog ports from the mitel [ Voicemail is called Billymail ] and is working however calls transferred to individual tel extentions do not call forward /busy to the voicemail but rings the extention and then the main message on the voicemail ports answer. This apparently just started happening possibly after power spike.
Can anyone help on these three issues? Upfront thanks .

Not familiar with the voice mail, but it sounds like it has lost voice mail boxes. When programming the 200 use the "escape" key before keying in the choices at the bottom.

The SX200D behaves, in general, like the SX200 D/L or the SX200 ML/EL when accessed through the serial port. Depending on port speed, it may be slow and unresponsive. Set your port to 9600-8-N-1 before doing the auto-baud and you stand a decent chance of getting a good response speed.

Did the hotline to the taxi ever work, or is this a new change?

How does the analog voicemail get integration information?

It sounds like you may be way over your head. I strongly suggest calling out the certified Mitel dealer in your area.

Also, you should point out to the owner that while it is a credit to Mitel that these systems are still in service, so many years after they've become obsolete, all good things must eventually come to an end. It is time NOW to begin planning for the upgrade to SX200 ICP.

WT, dollars to donuts this integration relies on speed-dials and the codes have been lost or forgotten.

tg, my thought exactly. That would also explain why the 'taxi' hotline doesn't work.

Helm-
We can PM if you want specifics on navigating thru programming. Usually the Hotline feature to go off property uses the call forward always feature on the station, usually pointing to a system speed dial number ( from 31 )and programmed from the station or at the console.

With the VM i would verify there are mailboxes for these ext's 1st, if they have VM boxes then I would check the call forwarding - it should go to a speed dial number that " should " contain the VM hunt group followed by some sequence of digits like *90*6*9 - the zero couls also be a digit one- these usually identiy a call forward or a check message string.

Of course this is all based on the assumption that these are anaolg vm ports and the BillyMail uses the same type of inband call integration as some of the other industry standard VMs. I myself am not familiar with BillyMail.