|
|
|
|
Joined: May 2005
Posts: 2
Member
|
|
Member
Joined: May 2005
Posts: 2 |
Hello,
I have a couple of questions about the new VMP U-40 card. I am using this in an IPK system.
1) Can the network port on the front of the unit be used to configure the system? If so, what is the IP address by default?
2) Using the VM/Remote Cosession software that came with card and 57600 Baud, I can not connect to the system. I can use the same machine on an older FMS system at 19200 baud and everything works fine. Any idea.
Help would be greatly appreciated!
Scott
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
|
Joined: Nov 2003
Posts: 1,313
Member
|
|
Member
Joined: Nov 2003
Posts: 1,313 |
1>as far as i know it is not used.
2>there is a default logon when using the vmp that has to be put into the cosessions software. give you a hint.....has to do with tech support & voicemail (1 is the logon the other is the password. and no it's not techsupport & voicemail but it's close!)
|
|
|
|
|
Joined: May 2005
Posts: 2
Member
|
|
Member
Joined: May 2005
Posts: 2 |
Chris,
Thanks for the reply. I did figure it out, it was the JP7 jumper. It needs to be on pins 1&2 not 2&3 (factory default to internal modem). Apparantly NEC didn't deem it necessary to put that little bit in the instructions.
Scott
|
|
|
|
|
Joined: Nov 2003
Posts: 1,313
Member
|
|
Member
Joined: Nov 2003
Posts: 1,313 |
oh yeah........that too...
sometimes nec has it set to a hard drive instead of compact flash too.
|
|
|
|
Forums84
Topics94,526
Posts640,017
Members49,852
| |
Most Online5,661
May 23rd, 2018
|
|
|
0 members (),
260
guests, and
49
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
