sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems IPKII Feature Codes

I am a trainer not an installer & subcontract to do end user training. I need to get a list of the feature codes for IPKII features to use for one touch key programming at the set level. Can anyone tell me where I can find these? I have several IPKll manuals but they have only a few of the codes & not some that customers need. Any help is appreciated. My website is www.sparetimescholar.com
Thanks

Station Speed Dial — Dial Access
To store a Station Speed Dialing number (display telephones only):
1. Press the Speaker key.
2. Dial 755.
3. Dial the Station Speed Dial buffer number to be programmed (0~9).
1 = Station Speed Dial buffer 1
2 = Station Speed Dial buffer 2
Etc....
0 = Station Speed Dial buffer 10
4. Dial the Access Code (e.g., 9) - if required.
5. Dial telephone number you want to store (up to 24 digits).
Note: Valid entries are 0~9, # and *. To enter a pause, press MIC. To
store a Flash, press Recall.
6. Press Hold.
7. Enter the name associated with the Speed Dialing number
(display telephones only):
Key for Entering Names
Use this
keypad
digit . . .
When you want to. . .
1 Enter characters 1 and other charecters.
2 Enter characters A-C, a-c, 2
3 Enter characters D-F, d-f, 3
4 Enter characters G-I, g-i, 4
5 Enter characters J-L, j-l, 5
6 Enter characters M-O, m-o, 6
7 Enter characters P-S, p-s, 7
8 Enter characters T-V, t-v, 8
9 Enter characters W-Z, w-z, 9
0 Enter characters 0 and other punctuation.
8. Press Hold.
9. Press the Speaker key to hang up.


DJ

Tip&Ring thanks for your reply but what I am trying to do is program the actual One Touch keys.
For Example to programm SD
Press Feature
Press Redial
Press 0
Press One Touch key
dial number to be stored
press Feature
I know how to do this for Speed Dial but not for other features like paging or forwarding. The customer wishes to access these and some other features by pressing a One Touch key.
Thanks so much for your answer though
LD

First press the Feature key and then the button to be programmed.
This will show what is programmed on that button.

The button to be programmed needs to be blanked first. To blank a button dial 752 then the button then dial 000 to clear it.

For one touch key dial 751, then the button to be programmed. Then dial 01, enter the digits needed, then press hold, to input name for button follow name definitions above, press hold then press Spkr. to quit.


DJ

Is this for the IPK or IPKII, as they are completely different from each other.

Scott.

There's a Codes Table in the back of the Features and Specs manual...but the revision level has to be 1100 or 1500. This table is sorted by feature name AND by number. Just remember, if you're going to program something use SPEAKER 751 to program a two digit code and SPEAKER 752 to program a three digit code.

These feature button codes are also in the multiline telephone user guide. Be advised, not all the features may be available. Some will have to be activated by a tecchnician.