sundance-communications.com/forum Forums TDM Business Telephone Systems NEC Telephones & Systems xn120

I have replaced a 0-8 ext card with an 3-08 card in slot 2 and moved the old card to slot 3
the problem is the co's wont come up.
I have the buttons programmed for co 4-6 and even tried setting one up as co 7
I have went through the line settings and could not see anything, so I am thinking it is something with slot to card settings

Normaly a panasonic-siemens man

Thanks

I have found the auto detection flackey on these systems some times.
Take a download of the system before you changed the card, Press F11 and set the cards in their new slots and check for the correct trunk assignment. Default the system and reload again. Usually sorts out the problem..

You need to connect to the XN-120 using PC Pro and take a download of the card configuration. Then remove the card physically and also remove it from the card configuration. Upload the card configuration without this card and then you can physically install the cards as these slots will now be blank. Hope this works

Thanks for your replies, I will be up there today and will try that, I was hoping it was only a program to tell the system the lines are connected

Will let ye know how it works out

Ok guys, thanks again for your advice.

What i did was( like ye said) I could not change the card in the software so I downloaded the system and modified the card type in batch and set up the trunks as required. then i defaulted the system. uploaded the new batch file and it worked first time.