|
Joined: Nov 2013
Posts: 1
Member
|
OP
Member
Joined: Nov 2013
Posts: 1 |
We have a customer with remote sites connected via wireless. I want to setup the ESI-Link between the sites using their existing network. Is this possible?
Site A (ESI100) 10.10.10.201 Site B (ESI50) 10.10.10.202 Site C (ESI50) 10.10.10.203
Gateway 10.10.10.1 Subnet 255.255.255.0
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
Joined: May 2005
Posts: 455
Member
|
Member
Joined: May 2005
Posts: 455 |
IVC cards from different systems can't be on the same subnet. It might work, but it's not supported because there is layer 1 and 2 taffic between cards on the same system that other systems are not supposed to see. You will need a router in front of each card to route the packets. It should work fine if you have good latency, etc.
|
|
|
|
Joined: Jan 2007
Posts: 1,217
Member
|
Member
Joined: Jan 2007
Posts: 1,217 |
I've done it once, I don't remember exactly how but I think the gateway of the local site was the IP address of the second site's IVC card.
Aaron
|
|
|
|
Joined: Feb 2014
Posts: 32
Member
|
Member
Joined: Feb 2014
Posts: 32 |
That is correct, if you only had 2 systems, but with 3 it is not likely you can do this. I am running into the same problem right now at a customer that has 2 remote sites, and 1 site that connects on the same subnet at the 700 cabinet. For some reason it works with the customers Cisco 1800 router at the 700 location, but they swapped it out for a ASA last week, and took down the 702 (locally connected) cabinet. We are thinking about putting a router in front of the 702 site to see if that will fix their issue.
|
|
|
Forums84
Topics93,969
Posts637,422
Members49,704
|
Most Online5,661 May 23rd, 2018
|
|
|
|