atcomsystems.ca/forum Forums TDM Business Telephone Systems Samsung Telephones & Systems CID Issue when i apply multi tenant on OS7200 connect using qsig with alcatel issue

I hv customer with huge pbx's network(alcatel & selta pbxs) , all pbx's in the network is connecting using Q sig .

In this network i installed OS7200 v4.7 sucessfully to alcatel PBX, & it's work using (Qsig basic 1) normally with one pri cards .


The mapping of network is:

The Customer want to Divided the OS7200 system to two tenant :

Subsystem A:

Node ID : 899
Extension number range:201,202,203,...,220

Subsystem B:

Node ID : 890
Extension number range:201,202,203,...,220


I make the following configuration:

MMC 812
Australia

MMC 803:

i dvided all ports as tenat 1 & tenant 2 as customers needed .

MMC 821:

Qsig Basic 1

MMC 824

LCR programming

MMC 210, 300,724,710,712,603

MMC 714
for incoming calls

I go to MMC 321: send CLI number

& program all extensions for tenat 1 as:

201 table1: 889201

202 table1: 889202
.
.
220 table1: 889203

program all extensions for tenat 2 as:

201 table1: 890201

202 table1: 890202
.
.
220 table1: 890203

plz note :

when i make call from tenant 1 or tenat 2 to alcatel work fine

But my problem on the CID appeare at Alcatel phone

i need when the ext (201) at samsunt tenant 1 call alcatel , the Caller ID at alcatel is 889201.

But actually the caller ID at alcatel phone is 201*889201
& the problem is the same when ext 201 at tenant 2 call alcatel, actually the caller ID at alcatel phone is 201*890201,

I want to remove (201*) before the 889201 or 890201









My problem how i can do that procedure?

.

Please if u can help me to solve this issue?

Plz any reply

Plz any reply

Any reason you're using QSIG Basic 1 and not just QSIG?

I've only ever done QSIG into CISCO and have only ever chosen QSIG (not basic 1 or 2) as the option.

What CLI table have you set in MMC420 for the QSIG PRI service?

plz any reply

my friends

with Qsig the connection between samsung & alcatel does not work

only on qsig basic 1

at MMC 840
table 1

i have one idea May be i need to use old version(like 4.6 )