I hv customer with huge pbx's network(alcatel & selta pbxs) , all pbx's in the network is connecting using Q sig .
In this network i installed OS7200 v4.7 sucessfully to alcatel PBX, & it's work using (Qsig basic 1) normally with one pri cards .
The mapping of network is:
The Customer want to Divided the OS7200 system to two tenant :
Subsystem A:
Node ID : 899
Extension number range:201,202,203,...,220
Subsystem B:
Node ID : 890
Extension number range:201,202,203,...,220
I make the following configuration:
MMC 812
Australia
MMC 803:
i dvided all ports as tenat 1 & tenant 2 as customers needed .
MMC 821:
Qsig Basic 1
MMC 824
LCR programming
MMC 210, 300,724,710,712,603
MMC 714
for incoming calls
I go to MMC 321: send CLI number
& program all extensions for tenat 1 as:
201 table1: 889201
202 table1: 889202
.
.
220 table1: 889203
program all extensions for tenat 2 as:
201 table1: 890201
202 table1: 890202
.
.
220 table1: 890203
plz note :
when i make call from tenant 1 or tenat 2 to alcatel work fine
But my problem on the CID appeare at Alcatel phone
i need when the ext (201) at samsunt tenant 1 call alcatel , the Caller ID at alcatel is 889201.
But actually the caller ID at alcatel phone is 201*889201
& the problem is the same when ext 201 at tenant 2 call alcatel, actually the caller ID at alcatel phone is 201*890201,
I want to remove (201*) before the 889201 or 890201
My problem how i can do that procedure?
.
Please if u can help me to solve this issue?