|
|
|
|
Joined: May 2005
Posts: 2
Member
|
OP
Member
Joined: May 2005
Posts: 2 |
Greetings,
I need to assign an IP address for a Partner Messaging R7 to connect on the LAN port. I use my cable and adapter and hyperterminal to connect to the RS232 port. OK so far. Now it asks for a logon and password. I tried "admin" and the 6 digit pw for the administrator as setup through x10 but no joy. I am assuming this is a standard logon and pw just to set the ip address. Anyone who can shed some light on this? Many thanks.
Grant
|
|
|
|
|
Joined: Mar 2001
Posts: 7,350
RIP Admin
|
|
RIP Admin
Joined: Mar 2001
Posts: 7,350 |
Passwords are not posted on the board due to security reasons, you will find what your looking for on page 15 in your Messaging System Administration manual.
Russ runs a local service and private tech center. ![[Linked Image from sundance-communications.com]](https://www.sundance-communications.com/installers/logos/65graphic.jpg) [/url]
|
|
|
|
|
Joined: May 2005
Posts: 2
Member
|
|
OP
Member
Joined: May 2005
Posts: 2 |
Many thanks. I had to go to the website and download the document. The System Manager's Quick Reference which was shipped with the unit didn't seem to mention it. I assume the document was supposed to be on the red and white CD that shipped with the system. Whomever was supposed to duplicate it, messed up. It shipped with a blank disk. Once I found the right document, it was there in black and white. Many thanks again. Check your e-mail.
Grant
|
|
|
|
|
Joined: Mar 2001
Posts: 7,350
RIP Admin
|
|
RIP Admin
Joined: Mar 2001
Posts: 7,350 |
That was very nice of you but I denied it, I didn't do anything special.
Russ runs a local service and private tech center. [/url]
|
|
|
|
Forums84
Topics94,279
Posts638,738
Members49,764
| |
Most Online5,661
May 23rd, 2018
|
|
|
1 members (C5Z),
117
guests, and
70
robots. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|
|
