|
|
Joined: Jul 2006
Posts: 53
Member
|
OP
Member
Joined: Jul 2006
Posts: 53 |
Hello all. I was sent to a customer with a merlin 2 system. I haven't worked on this system in years. I was able to figure out how to remove the lines from pool 9. But, I couldn't figure out how to assign specific lines to specific extensions. Not sure if it's me or not but the programming manual is not very helpful. The customer had a power outage and lost some programming. I suggested they upgrade to a legend r7 processor. But, they are a state run facility so you know how that goes. Can someone give me the steps I would need to assign the lines? Thanks, Brian
|
|
|
Forums84
Topics94,290
Posts638,801
Members49,767
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
85
guests, and
379
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|