sundance-communications.com Forums More-Phone & VoIP Systems Executone-Isoetec Telephones & Systems day ring group

I have 5 extensions ringing at the same time
as part of ring group, i need to modify the
existing programming, where do I do this at.

Be alot easier with some more info.What type of system are we talking about?

It's done in system programming, you'll need to edit the stations in the ringing groups program.

i have an ids 128 with acpu and tie trunk lines
and pri lines setup with did.

i dont see a "ringing group" on the system
page.

Do you have a group setup for incoming ringing or do you have several stations programmed to ring on lines?

Check station programming and see if lines are programmed to ring day/night at those extensions.

If you do not have voicemail that is probably the easiest way.

Good Luck!!

You might also have 1 phone ringing and other phones ringing off of a ringing pickup key.Check on the phones in question for a code like 901-9XX .

[This message has been edited by pvj (edited May 13, 2005).]

i have did lines that ring directly to all exts, there is no specific ring assignments
these all rin as a group that can bee seen on system status monitor bottom right hand on screen

If you watch the system status screen when the call rings in on the right hand side of the screen it should show where its ringing to.