|
|
|
|
Joined: Jun 2013
Posts: 7
Member
|
OP
Member
Joined: Jun 2013
Posts: 7 |
I am installing an EPM II, one of the more recent Indoor/Outdor RFID readers, and I am not sure which wires need to be connected to what. I know in the older ones, the station wires go in 1 and 2, and so on. On this one, the wires are attached to the circuit board and I need to know which is the common and NC connectors. Also, does the EPM II have a jumper to switch it from NO to NC? Any help would be greatly appreciated. Thanks!
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
|
Joined: Jan 2007
Posts: 1,217
Member
|
|
Member
Joined: Jan 2007
Posts: 1,217 |
Yellow leads to ESI extension port.
White to strike plate.
NO/NC jumper is on the main board of the unit, manual will tell you exactly how to change it from no to nc.
Aaron
|
|
|
|
|
Joined: Feb 2006
Posts: 1,716
Member
|
|
Member
Joined: Feb 2006
Posts: 1,716 |
In the box with the new reader is the instructions and wiring detail. Don't be afraid to cut the wires to make them shorter. Many times there's not enough room behind the reader to accommodate all that length of wire.
Rcaman
Americom, Inc.
Where The Art And Science Of Communications Meet
|
|
|
|
Forums84
Topics94,283
Posts638,765
Members49,764
| |
Most Online5,661
May 23rd, 2018
|
|
|
|
|
|
