|
|
Joined: Jul 2016
Posts: 2
Member
|
OP
Member
Joined: Jul 2016
Posts: 2 |
WE have 3 used IPT-2010-SD phones that i cannot enter programming mode to setup for our system. I was able to get in once on one of them but that was it.
It is a CIX100.
I am pressing the 3,6,9,Hold and nothing.
It says "IPAddress setting..." and then "Can't set IP Address"
When I was in that one time I noticed the phone was set to Manual IP.
Any advice is greatly appreciated.
Thanks
|
|
|
|
Joined: Jan 2010
Posts: 933 Likes: 1
Moderator-Toshiba
|
Moderator-Toshiba
Joined: Jan 2010
Posts: 933 Likes: 1 |
Have you plugged the curly handset cord into the headset port on the bottom of the phone? If you have then you are NOT able to get into handset programming via the 369 HOLD
Regards Carl
|
|
|
|
Joined: Jul 2016
Posts: 2
Member
|
OP
Member
Joined: Jul 2016
Posts: 2 |
That was it. Thank you so much. I found this no where i looked. Thanks again.
|
|
|
|
Joined: Jan 2010
Posts: 933 Likes: 1
Moderator-Toshiba
|
Moderator-Toshiba
Joined: Jan 2010
Posts: 933 Likes: 1 |
You will not be the last one to do it  Thanks for letting us know
Regards Carl
|
|
|
Forums84
Topics93,832
Posts636,785
Members49,648
|
Most Online5,661 May 23rd, 2018
|
|
0 members (),
193
guests, and
60
robots. |
Key:
Admin,
Global Mod,
Mod
|
|
|
|
|