|
|
|
|
Joined: Jul 2016
Posts: 2
Member
|
OP
Member
Joined: Jul 2016
Posts: 2 |
WE have 3 used IPT-2010-SD phones that i cannot enter programming mode to setup for our system. I was able to get in once on one of them but that was it.
It is a CIX100.
I am pressing the 3,6,9,Hold and nothing.
It says "IPAddress setting..." and then "Can't set IP Address"
When I was in that one time I noticed the phone was set to Manual IP.
Any advice is greatly appreciated.
Thanks
|
|
|
Visit Atcom to get started with your new business VoIP phone system ASAP
Turn up is quick, painless, and can often be done same day.
Let us show you how to do VoIP right, resulting in crystal clear call quality and easy-to-use features that make everyone happy!
Proudly serving Canada from coast to coast.
|
|
|
|
Joined: Jan 2010
Posts: 937 Likes: 2
Moderator-Toshiba
|
|
Moderator-Toshiba
Joined: Jan 2010
Posts: 937 Likes: 2 |
Have you plugged the curly handset cord into the headset port on the bottom of the phone?
If you have then you are NOT able to get into handset programming via the 369 HOLD
Regards
Carl
|
|
|
|
|
Joined: Jul 2016
Posts: 2
Member
|
|
OP
Member
Joined: Jul 2016
Posts: 2 |
That was it. Thank you so much. I found this no where i looked.
Thanks again.
|
|
|
|
|
Joined: Jan 2010
Posts: 937 Likes: 2
Moderator-Toshiba
|
|
Moderator-Toshiba
Joined: Jan 2010
Posts: 937 Likes: 2 |
You will not be the last one to do it  Thanks for letting us know
Regards
Carl
|
|
|
|
Forums84
Topics94,279
Posts638,739
Members49,764
| |
Most Online5,661
May 23rd, 2018
|
|
|
|
|
|
