sundance-communications.com/forum Forums TDM Business Telephone Systems Avaya - Lucent Telephones & Systems IP Office loud ringing paging

I Want to put in a new Avaya IPO Basic at a place that has a Valcom 2001A They want to keep the ringing and paging the way it is. Is there a interface I would need or can it work with out one? If so how

Thanks

You can designate a single line station port as a loudspeaker paging port, connect that to Tip and Ring page on the Valcom

Another single line station port can provide the ringing voltage for UNA Ringing over paging.

Are you SURE you want to put this in as Basic mode? Essential license is not that much, and adds so much more functionality!

For paging it can connect to an analog trunk or station port, same way as it probably is connected to the old system. Question is how are they doing the contact closure for the ringing on the old system?

-Hal

Thank you both
Touch Tone it is a small tire company. 3 lines and 5 phones
Hal it works on contact closer shorting when it rings

I get that, but it's unlikely the system (unless it's a 1A2) will provide that contact closure. So there's likely a relay that senses ring voltage and closes it's contacts between the system and the Valcom.

-Hal

If I can quote myself.....

And if I can quote you.

Connect the T/R from a single line station port to the UNA Ringing terminals. You don't use the UNA Closure terminals anymore.

(I had to look at the spec sheet to see what Tommy was talking about and see that there is an input for a 90v ringing signal in addition to a contact closure input.)

-Hal

Thank you all for the help

well hooked everything up but paging when dialing 70 for page gives me a error message on phone busy membership I think that was what it said and that was with just my test set in the port. Tech support told me to upgrade the system but it wont let me says something like transfer file failed the same when it moved to the next one the check marks are on the right of the file flie is in red. Not real sure why I would need to upgrade new system could it be something else?
Thanks

You're probably getting the error message on the upgrade because you're using the ADMINISTRATOR password for the upgrade. You need to use the SYSTEM password for that.