Phone Systems

Previous Thread
Next Thread
Print Thread
Rate Thread
IP Office loud ringing paging
#633032 09/29/19 05:31 PM
Joined: May 2007
Posts: 389
bditech Offline OP
Member
OP Offline
Member
Joined: May 2007
Posts: 389
I Want to put in a new Avaya IPO Basic at a place that has a Valcom 2001A They want to keep the ringing and paging the way it is. Is there a interface I would need or can it work with out one? If so how

Thanks

AT&T Systems and Telephones
Re: IP Office loud ringing paging
bditech #633037 09/29/19 07:11 PM
Joined: Jul 2001
Posts: 3,236
Moderator-Avaya-Lucent, Antique Tele
*****
Online Content
Moderator-Avaya-Lucent, Antique Tele
*****
Joined: Jul 2001
Posts: 3,236
You can designate a single line station port as a loudspeaker paging port, connect that to Tip and Ring page on the Valcom

Another single line station port can provide the ringing voltage for UNA Ringing over paging.

Are you SURE you want to put this in as Basic mode? Essential license is not that much, and adds so much more functionality!

Re: IP Office loud ringing paging
bditech #633038 09/29/19 07:12 PM
Joined: Feb 2005
Posts: 12,214
Member
***
Online Content
Member
***
Joined: Feb 2005
Posts: 12,214
For paging it can connect to an analog trunk or station port, same way as it probably is connected to the old system. Question is how are they doing the contact closure for the ringing on the old system?

-Hal


CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
Re: IP Office loud ringing paging
bditech #633050 09/30/19 04:34 PM
Joined: May 2007
Posts: 389
bditech Offline OP
Member
OP Offline
Member
Joined: May 2007
Posts: 389
Thank you both
Touch Tone it is a small tire company. 3 lines and 5 phones
Hal it works on contact closer shorting when it rings

Re: IP Office loud ringing paging
bditech #633052 09/30/19 06:12 PM
Joined: Feb 2005
Posts: 12,214
Member
***
Online Content
Member
***
Joined: Feb 2005
Posts: 12,214
Originally Posted by bditech

Hal it works on contact closer shorting when it rings


I get that, but it's unlikely the system (unless it's a 1A2) will provide that contact closure. So there's likely a relay that senses ring voltage and closes it's contacts between the system and the Valcom.

-Hal


CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
Re: IP Office loud ringing paging
bditech #633055 09/30/19 07:20 PM
Joined: Jul 2001
Posts: 3,236
Moderator-Avaya-Lucent, Antique Tele
*****
Online Content
Moderator-Avaya-Lucent, Antique Tele
*****
Joined: Jul 2001
Posts: 3,236
If I can quote myself.....

Quote
Another single line station port can provide the ringing voltage for UNA Ringing over paging.

Re: IP Office loud ringing paging
Touch Tone Tommy #633057 09/30/19 08:24 PM
Joined: Feb 2005
Posts: 12,214
Member
***
Online Content
Member
***
Joined: Feb 2005
Posts: 12,214
Originally Posted by Touch Tone Tommy
If I can quote myself.....

Quote
Another single line station port can provide the ringing voltage for UNA Ringing over paging.


And if I can quote you. blush

Connect the T/R from a single line station port to the UNA Ringing terminals. You don't use the UNA Closure terminals anymore.

(I had to look at the spec sheet to see what Tommy was talking about and see that there is an input for a 90v ringing signal in addition to a contact closure input.)

-Hal

Last edited by hbiss; 09/30/19 08:25 PM.

CALIFORNIA PROPOSITION 65 WARNING: Some comments made by me are known to the State of California to cause irreversible brain damage and serious mental disorders leading to confinement.
Re: IP Office loud ringing paging
bditech #633067 10/01/19 06:34 PM
Joined: May 2007
Posts: 389
bditech Offline OP
Member
OP Offline
Member
Joined: May 2007
Posts: 389
Thank you all for the help

Re: IP Office loud ringing paging
bditech #633154 10/06/19 11:30 AM
Joined: May 2007
Posts: 389
bditech Offline OP
Member
OP Offline
Member
Joined: May 2007
Posts: 389
well hooked everything up but paging when dialing 70 for page gives me a error message on phone busy membership I think that was what it said and that was with just my test set in the port. Tech support told me to upgrade the system but it wont let me says something like transfer file failed the same when it moved to the next one the check marks are on the right of the file flie is in red. Not real sure why I would need to upgrade new system could it be something else?
Thanks

Re: IP Office loud ringing paging
bditech #633155 10/06/19 02:02 PM
Joined: Aug 2006
Posts: 1,658
Moderator-Iwatsu
*****
Online Content
Moderator-Iwatsu
*****
Joined: Aug 2006
Posts: 1,658
You're probably getting the error message on the upgrade because you're using the ADMINISTRATOR password for the upgrade. You need to use the SYSTEM password for that.



Sometimes the thoughts in my head get so bored, they go for a stroll through my mouth. This is rarely a good thing.

Link Copied to Clipboard
Forum Search
Most Recent 5 Post
sip inbound robo calls
by sentrex1 - 06/04/20 04:20 PM
CIXs, SIP trunks, centralized voicemail
by LarryH2 - 06/03/20 10:46 PM
Profile 2 SIP Trunks
by Coral Tech - 06/03/20 07:28 PM
MGI audio deteriorating
by Bushmills - 06/03/20 04:08 PM
TDE 200 Drop Calls
by chazrc - 06/03/20 04:02 PM
Who's Online Now
46 members (EV607797, Curlycord, Bob-o, justbill, RATHER BE FISHING, hitechcomm, Carlos#1, ChrisRR, Mercenary Roadie, mongo5150, nortelvoip, newtecky, Touch Tone Tommy, dexman, MooreTel, sentrex1, JBean3329, nfcphoneman, Yoda, Keyset6, hbiss, jeffmoss26, Arthur P. Bloom, Professor Shadow, Bushmills, SSPhone, Daniel, dans, westerntelephone, KENB, Why Me!!!, pvj, Bob3470, Carl Navarro, Avidcomm, iatech3800, Memphisribs, seafort, KRRath, gelehu, ILE, Rok1215, metelcom, C5Z, erniejoey, helpifican), 482 guests, and 36 robots.
Key: Admin, Global Mod, Mod
Popular Topics (Views)
Forum Statistics
Forums94
Topics93,742
Posts635,978
Members49,292
Most Online5,661
May 23rd, 2018
Today's Birthdays
charlotte, Harry Smith, Ritztech
Newest Members
swoodsNI, B. Endsley, Abner Dawes, Gringo, Jeffrey Cohen
49292 Registered Users
Get Tech Support Now! Click the banner below
Get Tech Support Now!
EMP & Lightning Home Surge Protection
EMP - Click Here!
Top Posters (30 Days)
dexman 25
ChrisRR 11
Bob-o 8
Bluewater Sailing
https://www.patreon.com/bePatron?u=5256033
EMP Shield for Commercial - Home & Vehicle
Use Coupon code SAVE - Click Here!
Servpro Ventura 24-Hour Emergency Service
Free Estimates call us now 24Hours
Contact Us | Telephone System Tech Support | Terms of Service

Sundance Communications is not affiliated with any of the above manufacturers.
©Copyright Sundance Communications 1998-2020
Trusted Partners