sundance-communications.com Forums Telephony Discussion Phone & VoIP Systems NEC Telephones & Systems foward all calls

our systemm is a NEC 2000 IPS. The problem is i foward all calls to my cell phone and when ther is a call from the out side the switch board can not release the call till i answer my cell phone.
If I could get any help in this matter it would be helpful. Thank You Brad

Check this program's settings:

08>206=0
08>253=0
08>324=0
08>028=0
08>063=0

Verify Program 360 for route to route connection, although this is most likely correct or it wouldn't work at all.

D

Thank you for your responce
I changed
08>206 From a 1 to 0
08>253 From a 1 to 0
08>324 From a 1 to 0
and
08>028
08>063
were set to 0

and the switchboard still can not release the call
Command 360 looks alright.
If you have any other ideas it would be helpful. Brad

That's odd, because I had the exact same issue with a CP24 I had to C-load and the 08 commands are what got me going ok.....

You may need to contact NTAC if you can after the holiday.

D

I will contact then on Monday thanks for all your help.
Brad

Don't have a manual to hand (in Dempasar airport going home) but there is another 08 Cmd around the 400s I think for post dialling on an ISDN call which will give this exact problem if set wrong.

R4+Z I looked in the 400's but I could not find anything that helped the problem.
Brad

Try 410>03>xx & set to 00.

DrPbx that command is set to 410>03:00.
Brad

Try Cmd 08 de 405 If I remember correctly it's worded a bit strange in the manual and you wouldn't expect it to have the effect it does! First time I experienced the problem I had to get TAC to find the solution for me and it took them a day to get back to me with the answer! Let us know if it works as I've lost the email that has the specifics in it.