Its in sight, if you have really really good vision...lol

I picked up the ATA186's today. I will start to fight with them tomorrow. In Cisco's infinite wisdom, I as the end user cannot download the UC560 software package, without providing them a service contract number. The serial number registered to me for my new system is not enough, so I must wait until I can get a copy from my vendor.

This is needed to install the phone packages for the ATA's.

Other then that, its only scripting and AA tweaks then I can give them the go ahead to start porting numbers over.

I am going to see if they will allow me to cut locations over one at a time instead of all at once. This will allow me to track down any issues easier then if they all dropped at once.


Anyone know if I can link a DID to an AA submenu?

I would like to setup one main AA with each "program" having a submenu. Then I would like to have a DID point directly to that submenu. I have no clue if this is possible! If its not, then I will have to setup individual AA for each program, there would only be 4, but I like 1 better then 4 for admin purposes.